Heat of Vaporization Estimator (Trouton Rule)

Get a quick heat of vaporization from a boiling point, check it against a known value, and scale it to another temperature.

♨️ Heat of Vaporization Estimator (Trouton Rule)
Liquid preset (illustrative)
Estimation method
Normal boiling point (Tb)
K
Trouton constant
J/(mol K)
Known dHvap (optional)
kJ/mol
Liquid preset (illustrative)
dHvap at Tb
kJ/mol
Boiling point (Tb)
K
Critical temperature (Tc)
K
Target temperature (T)
K
Watson exponent (n)
Estimated dHvap
—
Entropy used
—
Trouton range (85 to 88)
—
Kistiakowsky estimate
—
Error vs known value
—
Known value as dS
—

dHvap at T
—
Ratio dH(T) / dH(Tb)
—
Reduced Tb (Tb / Tc)
—
Reduced T (T / Tc)
—
dS = dH / T
—
Change from dH at Tb
—

♨️ What is Trouton's Rule?

Trouton's rule is an empirical observation made by Frederick Trouton in 1884: for many liquids the molar entropy of vaporization at the normal boiling point is almost the same, close to 85 to 88 J/(mol K). Because the entropy of vaporization equals the enthalpy of vaporization divided by the boiling temperature, the rule gives a fast way to estimate the heat needed to boil one mole of a liquid when only the boiling point is known. You multiply the boiling point in kelvin by about 88 J/(mol K), and the answer is the enthalpy of vaporization.

The estimate is handy in practice. A process engineer screening solvents can guess how much heat a distillation will need before looking up data. A chemist can check whether a published heat of vaporization is plausible. A student can see why a liquid with a high boiling point is also costly to evaporate. The same idea, combined with Watson scaling, lets you move a known value at the boiling point to room temperature, where evaporation of solvents and the drying of coatings usually happen.

The rule has well-known limits. Liquids with strong hydrogen bonding, such as water and ethanol, gain more entropy on vaporization because the liquid is unusually ordered, so Trouton's constant gives values that are too low. Very light molecules such as methane gain less, so the rule gives values that are too high. The Kistiakowsky-type formula, which lets the entropy grow slowly with the boiling point, does better for a wide range of non-polar liquids but shares the same weakness for associated liquids.

This estimator offers two modes. The first estimates the enthalpy of vaporization from Tb with either method and compares it with a known value if you give one. The second applies the Watson relation to scale a known enthalpy at the boiling point to any temperature below the critical temperature. The presets for liquids are rounded and illustrative, and each mode has a chart that shows the trend behind the number.

📐 Formula

ΔHvap  ≈  Tb × ΔSvap,   ΔSvap ≈ 85 to 88 J/(mol K)
Tb = normal boiling point in K
ΔSvap = molar entropy of vaporization at Tb (Trouton constant, default 88 J/(mol K))
Kistiakowsky type: ΔSvap ≈ 36.6 + R ln Tb in J/(mol K), with R = 8.314 J/(mol K) (approximate constant)
Example: benzene, Tb = 353.2 K gives ΔHvap = 88 × 353.2 / 1000 = 31.08 kJ/mol
ΔH2  =  ΔH1 × [ (1 − Tr2) ÷ (1 − Tr1) ]n
Tr = T / Tc, the reduced temperature
n = Watson exponent, usually 0.38
Example: water, ΔH1 = 40.65 kJ/mol at 373.15 K, Tc = 647.1 K, target 298.15 K gives ΔH2 = 44.57 kJ/mol

📖 How to Use This Calculator

Steps

1
Choose estimate or scaling - Estimate from Tb uses the boiling point alone. Scale with Watson moves a known enthalpy to another temperature.
2
Enter the liquid data - Pick a preset to fill the boiling point (and critical temperature) or type your own values. Typed values are never changed by the preset list afterwards.
3
Read the result - The primary box gives the enthalpy of vaporization. The other boxes show the entropy, the Trouton range and the error against a known value.
4
Check the chart - One chart compares the two estimates across boiling points, and the other shows the Watson curve falling to zero at Tc.

💡 Example Calculations

Example 1 - Benzene by Trouton's rule

Tb = 353.2 K, constant 88 J/(mol K), known value 30.7 kJ/mol (approximate)

1
ΔH = 88 × 353.2 = 31,081.6 J/mol = 31.08 kJ/mol.
2
The 85 to 88 J/(mol K) range gives 30.02 to 31.08 kJ/mol. The Kistiakowsky estimate is 30.16 kJ/mol.
3
Error = (31.08 − 30.7) / 30.7 = +1.2 %. The known value corresponds to 86.9 J/(mol K).
ΔHvap = 31.08 kJ/mol, error +1.2 %
Try this example →

Example 2 - Ethanol with the Kistiakowsky form

Tb = 351.4 K, known value 38.6 kJ/mol (approximate)

1
ΔS = 36.6 + 8.314 × ln(351.4) = 85.34 J/(mol K).
2
ΔH = 85.34 × 351.4 = 29.99 kJ/mol.
3
Error = (29.99 − 38.6) / 38.6 = −22.3 %. The known value corresponds to 109.8 J/(mol K), well above the normal range, because ethanol is hydrogen bonded.
ΔHvap = 29.99 kJ/mol, error −22.3 %
Try this example →

Example 3 - Water at 25 °C by Watson scaling

ΔH = 40.65 kJ/mol at 373.15 K, Tc = 647.1 K, T = 298.15 K

1
Tr at Tb = 373.15 / 647.1 = 0.5766, and Tr at T = 298.15 / 647.1 = 0.4607.
2
Ratio = ((1 − 0.4607) / (1 − 0.5766))0.38 = 1.27380.38 = 1.0963.
3
ΔH = 40.65 × 1.0963 = 44.57 kJ/mol, an increase of 3.92 kJ/mol.
ΔHvap(298.15 K) = 44.57 kJ/mol
Try this example →

Example 4 - Benzene near its critical region

ΔH = 30.7 kJ/mol at 353.2 K, Tc = 562 K, T = 450 K

1
Tr at Tb = 0.6285 and Tr at 450 K = 0.8007.
2
Ratio = (0.1993 / 0.3715)0.38 = 0.7892.
3
ΔH = 30.7 × 0.7892 = 24.23 kJ/mol, a drop of 6.47 kJ/mol, and ΔS = 24,230 / 450 = 53.8 J/(mol K).
ΔHvap(450 K) = 24.23 kJ/mol
Try this example →

❓ Frequently Asked Questions

What is Trouton's rule?+
Trouton's rule says that the molar entropy of vaporization at the normal boiling point is roughly the same for many liquids, about 85 to 88 J/(mol K). Multiplying that constant by the boiling point in kelvin gives an estimate of the enthalpy of vaporization.
How do you estimate the heat of vaporization from the boiling point?+
Use dH = dS x Tb with dS about 88 J/(mol K). For benzene, with Tb = 353.2 K, dH = 88 x 353.2 = 31,082 J/mol, which is 31.08 kJ/mol. The measured value is about 30.7 kJ/mol, so the estimate is 1.2 percent high.
Why does Trouton's rule fail for water?+
Hydrogen bonding makes the liquid more ordered than a typical non-polar liquid, so more entropy is gained on vaporization. Water's entropy of vaporization at its boiling point is about 109 J/(mol K), so the rule gives about 32.8 kJ/mol against a true value near 40.7 kJ/mol.
What is the Kistiakowsky equation?+
It is an improved estimate that lets the entropy of vaporization grow slowly with the boiling point: dS = 36.6 + R ln Tb in J/(mol K), where R is the gas constant. It is better than a fixed constant for non-polar liquids over a wide range of boiling points. The constant 36.6 is approximate.
What is the Watson equation?+
The Watson equation scales the enthalpy of vaporization from one temperature to another: dH2 = dH1 x ((1 - Tr2) / (1 - Tr1))^0.38, where Tr is the temperature divided by the critical temperature. It makes dH fall to zero at the critical point.
How do you find the heat of vaporization of water at 25 C?+
With dH = 40.65 kJ/mol at Tb = 373.15 K and Tc = 647.1 K, Watson scaling to 298.15 K gives about 44.57 kJ/mol. Measured values near 44 kJ/mol show that the 0.38 exponent is a good but approximate rule.
Which liquids obey Trouton's rule best?+
Non-polar and weakly polar liquids with roughly spherical or modest-sized molecules, such as benzene, hexane, chloroform and carbon tetrachloride, follow the rule within a few percent. Associated liquids and very light liquids deviate.
What units does the estimator use?+
Temperatures are in kelvin, entropies in J/(mol K) and enthalpies in kJ/mol. The estimate is molar, so to get a value per gram you divide by the molar mass.
Why must the temperature be below the critical temperature for Watson scaling?+
At the critical temperature the liquid and vapour become identical and the heat of vaporization is zero. The factor 1 - Tr would be zero or negative above Tc, so no real value exists there.
How accurate is the estimate?+
For good Trouton liquids the error is a few percent. For water or ethanol it can be 20 percent or more, and for methane about 20 percent in the other direction. The error output in this tool shows the difference when you supply a known value.

📚 Sources and Notes

The rule and its exceptions follow the Wikipedia article on Trouton's rule and the Wikipedia article on the entropy of vaporization. The Watson form with an exponent of 0.38 is described in the thermo documentation on phase change properties. The constant 36.6 in the Kistiakowsky-type formula is the commonly quoted rounded value and is approximate; A more exact value was not confirmed. Boiling points, critical temperatures and reference enthalpies in the presets are rounded and illustrative.

See also the boiling point calculator, the vapor pressure calculator and the enthalpy calculator.

What is Trouton's rule?

Trouton's rule says that the molar entropy of vaporization at the normal boiling point is roughly the same for many liquids, about 85 to 88 J/(mol K). Multiplying that constant by the boiling point in kelvin gives an estimate of the enthalpy of vaporization.

How do you estimate the heat of vaporization from the boiling point?

Use dH = dS x Tb with dS about 88 J/(mol K). For benzene, with Tb = 353.2 K, dH = 88 x 353.2 = 31,082 J/mol, which is 31.08 kJ/mol. The measured value is about 30.7 kJ/mol, so the estimate is 1.2 percent high.

Why does Trouton's rule fail for water?

Hydrogen bonding makes the liquid more ordered than a typical non-polar liquid, so more entropy is gained on vaporization. Water's entropy of vaporization at its boiling point is about 109 J/(mol K), so the rule gives about 32.8 kJ/mol against a true value near 40.7 kJ/mol.

What is the Kistiakowsky equation?

It is an improved estimate that lets the entropy of vaporization grow slowly with the boiling point: dS = 36.6 + R ln Tb in J/(mol K), where R is the gas constant. It is better than a fixed constant for non-polar liquids over a wide range of boiling points. The constant 36.6 is approximate.

What is the Watson equation?

The Watson equation scales the enthalpy of vaporization from one temperature to another: dH2 = dH1 x ((1 - Tr2) / (1 - Tr1))^0.38, where Tr is the temperature divided by the critical temperature. It makes dH fall to zero at the critical point.

How do you find the heat of vaporization of water at 25 C?

With dH = 40.65 kJ/mol at Tb = 373.15 K and Tc = 647.1 K, Watson scaling to 298.15 K gives about 44.57 kJ/mol. Measured values near 44 kJ/mol show that the 0.38 exponent is a good but approximate rule.

Which liquids obey Trouton's rule best?

Non-polar and weakly polar liquids with roughly spherical or modest-sized molecules, such as benzene, hexane, chloroform and carbon tetrachloride, follow the rule within a few percent. Associated liquids and very light liquids deviate.

What units does the estimator use?

Temperatures are in kelvin, entropies in J/(mol K) and enthalpies in kJ/mol. The estimate is molar, so to get a value per gram you divide by the molar mass.

Why must the temperature be below the critical temperature for Watson scaling?

At the critical temperature the liquid and vapour become identical and the heat of vaporization is zero. The factor 1 - Tr would be zero or negative above Tc, so no real value exists there.

How accurate is the estimate?

For good Trouton liquids the error is a few percent. For water or ethanol it can be 20 percent or more, and for methane about 20 percent in the other direction. The error output in this tool shows the difference when you supply a known value.